KIT-DRIVESHAFT INERTIA WELDED SHAFT W/WELDED, SINGLE-LEAD HARDENED STEEL WORM AT FRONT TO DRIVE THE WHEEL WORM GEAR, & WELDED SIX-LEAD HARDENED STEEL WORM AT REAR TO DRIVE THE TILLER GEAR (ALSO INCLUDES PRESSED-ON #1714 REAR ROLLER BEARING, RACE FOR BEARING, & #9301
MTD-10360
5
Washer, Flat, 1.50 x 1.75 x .010 SHIM BETWEEN DRIVE SHAFT REAR BEARING & REAR BEARING CAP TO ACHIEVE 5-TO- 10 THOUSANDTHS OF AN INCH (.005"-.010") END PLAY ON DRIVE SHAFT.
MTD-736-04308
5
BLADE:46":SIDE:HOP 532-405380 SHIM BETWEEN DRIVE SHAFT REAR BEARING & REAR BEARING CAP TO ACHIEVE 5-TO- 10 THOUSANDTHS OF AN INCH (.005"-.010") END PLAY ON DRIVE SHAFT.
MTD-742-05107-4046
5
Washer, Flat, 1.50 x 1.75 x .005 SHIM BETWEEN DRIVE SHAFT REAR BEARING & REAR BEARING CAP TO ACHIEVE 5-TO- 10 THOUSANDTHS OF AN INCH (.005"-.010") END PLAY ON DRIVE SHAFT.
MTD-736-04306
xx
Shim Set (INCL. FOLLOWING SHIMS:TWO #1224-1;TWO #1224-2;ONE #1224-3)
MTD-GW-1325C
